X friendship bracelet pattern (8 strings)
8 strings · 2 colours · about 95 cm each
Your colours
Tie along
Floss in hand? Tap Next.Knot diagram
Tap a knot to light its stringsCircle = knot in its colour. ↘ forward, ↙ backward, > forward-backward, < backward-forward. Letters = strings, left to right at the start.
Shows one repeat of 8 rows; the pattern then starts again.
How this pattern works
Part of the Diamonds family, the X pattern uses 8 strings to form crossing diamond shapes in 2 colours. Knot the strings along diagonal paths that run both ways. For a 16 cm knotted length, cut each string to about 95 cm.
Arrange A and B in colour 1 (Bright Red, DMC 666), C through F in colour 2 (Snow White, DMC B5200), then G and H in colour 1 (Bright Red, DMC 666). Red frames the row, while white occupies the centre where the X shapes cross.
A full pass through the design takes 16 forward knots and 12 backward knots. As you knot, each string travels diagonally across the middle to build the diamonds. The starting colours line up again after 8 rows, and the sequence starts over.
Red marks the two outside edges; white fills the centre and makes the crossing lines clear. Check each knot direction in the diagram as you move strings along diagonal paths, keeping the X shapes even.
Tips for this pattern
- Check the setup before you start: A, B, G and H use Bright Red (DMC 666), and C through F use Snow White (DMC B5200). Red on each side helps balance the crossing shapes as the rows grow.
- Work all 8 rows before checking the colour layout: the starting arrangement appears again at that point.
- Watch each string at the centre for a change in direction. The diagram shows whether its next diagonal goes left or right.
Questions about X pattern
How many strings does the X pattern use?
This design has 8 strings in 2 colours. Assign colour 1 (Bright Red, DMC 666) to A, B, G and H; use colour 2 (Snow White, DMC B5200) for C, D, E and F.
How many rows are in the X pattern repeat?
The colour setup appears again after 8 rows. Finish the full sequence, then check that the colours occupy their starting places.
Is the X friendship bracelet pattern hard to make?
It has medium difficulty and uses forward knots and backward knots. Make them as the strings travel diagonally across the centre to form the crossing diamonds.
Knots in this pattern
X pattern uses forward knot and backward knot. Tap a knot to see it drawn step by step.
Make a matching pair
Tie the same bracelet for a friend: same colours, swapped colours or a mirror image, with one cut list for both.
Open the matching pair makerMake your own
Three ways to a bracelet that is yours alone.